Related Experiment Video
Updated: Jan 2, 2026

Automated Interactive Video Playback for Studies of Animal Communication
Published on: February 9, 2011
Distributed bipartite leader-following consensus of linear multi-agent systems with input time delay based on
Yuliang Cai1, Huaguang Zhang2, Juan Zhang1
1College of Information Science and Engineering, Northeastern University, Shenyang, Liaoning, 110004, China.
Abstract:
This study focuses on the distributed bipartite consensus tracking for linear multi-agent systems with input time delay based upon event-triggered transmission mechanism. Both cooperative interaction and antagonistic interaction between neighbor agents are considered. A novel distributed bipartite control technique with event-triggered mechanism is raised to address this consensus issue. Different from the existing methods, our control technique does not need continuous communication among agents, is capable of addressing the case of input delay, and is applicable for the signed communication topology. Moreover, to avoid continuous monitoring of one's own state, a self-triggered control strategy is further proposed. And when the system states cannot be measured, the observer-based bipartite control technique with event-triggered mechanism is thus put forward. Furthermore, the results in leader-following consensus are extended to containment control. It is proven that the proposed controllers fulfill the exclusion of Zeno behavior in two consensus problems. Finally, simulation experiments are used to test the practicability of the theoretical analysis.
Related Concept Videos
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be...
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Transmission-Line Differential Equations
Line Section Model
A circuit representing a line section of length Δx helps in understanding the transmission line parameters. The voltage V(x) and current i(x) are measured from...
Linear Approximation in Time Domain
For a simple pendulum with a mass evenly distributed along its length and the center of mass located at half the pendulum's length,...
Classification of Systems-I
Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:
BIBO stability of continuous and discrete -time systems
To determine the BIBO stability, the convolution integral is utilized when a bounded continuous-time input is applied to a Linear Time-Invariant (LTI) system....

