Related Experiment Video
Updated: Jan 2, 2026

A Finite Element Approach for Locating the Center of Resistance of Maxillary Teeth
Published on: April 8, 2020
Photoelastic analysis of tension distribution in different orthodontic approaches for closing anterior open bites
Gladistone C Meros1, Alcides Jr Gonini2, Murilo B Lopes2
1Department of Orthodontics, São Leopoldo Mandic Dental School and Research Center, Campinas, São Paulo, Brazil - gladistone.fb@gmail.com.
Background:
This study aims to evaluate tension distribution in the anterior region of the mandible during two orthodontic mechanical approaches to treat anterior open bite.
Methods:
It was an in-vitro experimental study, that analyzed 5 models of photoelastic resin, simulating a lower dental arch. The anterior teeth underwent orthodontic forces of the Blue Elgiloy® 0.016" x 0.022" (MEAW technique) and Gummetal® 0.018"x 0.022" (GEAW technique) archwires. Tension distribution was assessed on three different points in the lower dental midline and was measured using a reflection polariscope. The archwires were evaluated with and without anterior elastic bands (6 oz, 170 g) installed between lateral incisors and lower canines, as recommended for anterior open bite.
Results:
The highest magnitudes of tension generated by the archwires were observed in the cervical regions of the teeth (on average 50% higher than those at the most apical point) regardless of the technique used. Comparatively, the GEAW technique showed significantly (P<0.05) lower tension values (16 MPa) than the MEAW technique using Blue Elgiloy (24 MPa).
Conclusions:
The GEAW technique showed a more favorable tension distribution pattern than the MEAW approach. The use of elastic bands improved tension distribution, regardless of the technique. The results also suggest that the use of anterior elastic bands in both techniques reduced the tensions released by the intrusive forces generated by the archwires.
Related Concept Videos
Flexural Stress
Hooke's Law states that within the material's elastic limits, stress is directly proportional to strain. In a member experiencing a bending moment, the strain at any point is relative to its distance...
Eccentric Axial Loading in a Plane of Symmetry
Symmetric Member in Bending
Members Made of Elastoplastic Material
As the bending moment...
General Case of Eccentric Axial Loading
Consider a member subjected to equal and opposite forces that are applied along a line that does not coincide with the member's neutral axis. In unsymmetrical...
Unsymmetric Bending - Angle of Neutral Axis
When a bending moment is applied at an angle θ concerning the vertical axis of a symmetrical member, it can be resolved into components along the member's principal...

