Related Experiment Video
Updated: Jan 2, 2026

Physical, Chemical and Biological Characterization of Six Biochars Produced for the Remediation of Contaminated Sites
Published on: November 28, 2014
Biochar made from low density wood has greater plant available water than biochar made from high density wood
Joerg Werdin1, Tim D Fletcher1, John P Rayner1
1School of Ecosystem and Forest Sciences, Faculty of Science, The University of Melbourne, 500 Yarra Boulevard, Richmond 3121, Victoria, Australia.
Abstract:
Soil water limitations often restrict plant growth in unirrigated agricultural, forestry and urban systems. Biochar amendment to soils can increase water retention, but not all of this additional water is necessarily available to plants. Differences in the effectiveness of biochar in ameliorating soil water limitations may be a result of differences in feedstock cell structure. Previous research has shown that feedstock cell structure influences the pore structure of biochar and consequently the volume available for water storage. The availability of this water for plant uptake will be determined by biochar pore diameters, given its role in determining capillary forces which plants must overcome to access pore water. Therefore, we hypothesized that differences in hardwood feedstock cell structure would result in differences in the plant available water holding capacity of biochar. Before pyrolysis, we measured the wood morphology of 18 Eucalyptus species on three replicates of equal age on a gradient of wood density (572-960 kg m-3). Wood samples were then pyrolysed (550 °C) and the resulting biochars were sieved and their particle size distribution was standardised before their physical properties, including water holding capacity, plant available water and bulk density were measured. Our results show that biochar made from lower density eucalypt wood had up to 35% greater water holding capacity and up to 45% greater plant available water than biochar made from higher density eucalypt wood. Further, feedstock wood density related well to fibre cell wall thickness and fibre lumen diameter. Therefore, wood density could be used as a proxy for wood cell structure, which can in turn be used to predict plant available water in biochar. The simple measure of feedstock wood density can inform feedstock choices for producing biochars with greater plant available water, optimal for the use as soil amendment in water limited environments.
Related Concept Videos
Softwoods and Hardwoods
Introduction to Wood
The structural integrity of the...
Density
Wood Products
Glue-laminated wood, often referred to as glulam, combines multiple smaller pieces of dimensional lumber using adhesives to form a single, larger piece. Cross-laminated timber consists...
Seasoning of Wood
Achieving equilibrium moisture content is the goal of seasoning; this is the point where the wood's moisture content stabilizes to align with the moisture levels of the surrounding environment. Proper...

