Related Experiment Video
Updated: Jan 1, 2026
Four-Dimensional Computed Tomography-Guided Valve Sizing for Transcatheter Pulmonary Valve Replacement
Published on: January 20, 2022
3-Dimensional personalized planning for transcatheter pulmonary valve implantation in a dysfunctional right
Francesca R Pluchinotta1, Francesco Sturla2, Alessandro Caimi3
1Department of Pediatric and Adult Congenital Heart Disease, IRCCS Policlinico San Donato, San Donato Milanese, Italy; Department of Electronics, Information and Bioengineering, Politecnico di Milano, Milano, Italy.
Background:
Identification of adequate landing zone for transcatheter pulmonary valve implantation (TPVI) is crucial to successfully treat an aneurysmatic native right ventricle outflow tract (RVOT); three-dimensional (3D) patient-tailored digital and physical printed models are available but their actual strengths and weaknesses still not well documented. The aim of the study was to tackle TPVI planning in the dysfunctional and borderline RVOT exploiting both digital and physical printed 3D patient-specific models.
Methods:
Electrocardiographically gated computed tomography (CT) angiography was segmented and anatomical RVOT geometrical changes dynamically tracked throughout the cardiac cycle using in-house processing. A compliant 3D-printed model was manufactured from the diastolic rest phase to test in vitro the catheter-based procedure feasibility; results were compared against CT-derived in vivo measurements and the actual catheterization outcome.
Results:
CT-gated analysis successfully quantified in vivo RVOT dynamic changes corroborating the feasibility of non-conventional pulmonary jailing percutaneous intervention. Clinicians used the 3D-printed model to test the steps of the jailing procedure; yet, the deformable 3D model printed at diastole underestimated the final implant dimensions obtained during cardiac catheterization by the same operators.
Conclusions:
Multidisciplinary synergy between CT-gated analysis and pre-procedural tests on 3D-printed phantoms can help the interventional team to tackle complex TPVI procedures. To fully exploit 3D-printed models, adequate selection of the still frame to print and tuning of printing material properties is crucial and can be aided by 3D dynamic virtual models.
