Related Experiment Video
Updated: Jan 1, 2026

The MODS method for diagnosis of tuberculosis and multidrug resistant tuberculosis
Published on: August 11, 2008
Use of sodium dodecyl sulfate to improve tuberculosis sputum smear microscopy
Yeya Dit Sadio Sarro1, Ousmane Kodio1, Alisha Kumar2
1University of Sciences, Techniques and Technologies of Bamako (USTTB), Bamako, Mali.
Abstract:
Sputum smear microscopy (SSM), the most widely available tool for tuberculosis (TB) detection, has limited performance in paucibacillary patients and requires highly experienced technicians. The objective of this study was to determine whether the addition of sodium dodecyl sulfate (SDS), a detergent that thins sputum, at 4% and 10%, improves the detection of acid-fast bacilli (AFB), the clarity of slides, and the biosafety of the technique. Thirty participants with presumptive TB were enrolled. Three independent, blinded technicians examined the slides. Regular sputum concentrated AFB smear and sputum culture were used as standard control methods. Sputum culture was also performed before and after 10% SDS addition for safety analysis. We found that neither SSM with SDS 4% nor SSM with SDS 10% improved the test's performance. However, slides with 4% and 10% SDS, compared with slides prepared without SDS, had significantly better clarity scores. The 10% SDS-prepared sputum samples were all culture negative. While adding SDS detergent does not improve the performance of SSM slides, it does improve the clarity and biosafety. Where experienced technicians are scarce, especially in low resource settings, use of SDS may enhance the ease of slide reading in sputum smear microscopy.
Related Concept Videos
Sputum Studies I: Gram Stain, cytology, and Acid-fast smear and culture
Gram Stain
The Gram Stain is an integral part of sputum studies. It involves the staining of sputum, which permits...
Sputum Studies II: Culture and Sensitivity
Sputum culture and sensitivity is a medical procedure used to diagnose bacterial infections in the respiratory tract and select the most appropriate antibiotics for treatment. This process involves analyzing sputum samples of thick and opaque secretions produced in the lungs and airways. These samples are collected from patients and then sent to the laboratory for analysis.
The test can identify various pathogens responsible for respiratory infections, including Streptococcus,...
Pulmonary Tuberculosis V
Latent tuberculosis infection occurs when TB bacteria are present in a person's body, but are not causing illness or symptoms. It is not contagious, and preventive treatment is crucial to avoid the...
Pulmonary Tuberculosis IV
Several diagnostic approaches are used to detect TB. The conventional method is the Tuberculin Skin Test (TST), also known as the Mantoux test. However, this method has...

