Related Experiment Video
Updated: Dec 31, 2025

Implementation of Portable Emissions Measurement Systems PEMS for the Real-driving Emissions RDE Regulation in Europe
Published on: December 4, 2016
Particulate emissions from L-Category vehicles towards Euro 5
A Kontses1, L Ntziachristos1, A A Zardini2
1Laboratory of Applied Thermodynamics, Aristotle University of Thessaloniki, P.O. Box 458, GR 54124, Thessaloniki, Greece.
Abstract:
The current experimental study presents particulate emissions from 30 Euro 1-4 L-category vehicles (i.e. 2-, 3- and 4-wheelers such as mopeds, motorcycles, quads and minicars, registered in Europe between 2009 and 2016) tested on a chassis dynamometer. The objectives were to identify those sub-categories with high emissions, to assess whether the measures prescribed in the Euro 5 legislation will effectively control particulate emissions and finally to investigate the need for additional measures. The results showed that 2-stroke (2S) mopeds and diesel minicars comprised the vehicles with the highest particulate mass (PM) and solid particle number above 23 nm (SPN23) emissions (up to 64 mg/km and 4.5 × 1013 km-1, respectively). It is uncertain whether the installation of diesel particulate filters (DPF) is a cost-effective measure for diesel mini-cars in order to comply with Euro 5 standard, while advanced emission controls will be required for 2S mopeds, if such vehicles remain competitive for Euro 5. Regarding 4-stroke mopeds, motorcycles and quads, PM emissions were one order of magnitude lower than 2S ones and already below the Euro 5 limit. Nevertheless, SPN23 emissions from these sub-categories were up to 5 times higher than the Euro 6 passenger cars limit (6 × 1011 km-1). Even recent Euro 4 motorcycles exceeded this limit by up to 3 times. These results indicate that L-category vehicles are a significant contributor to vehicular particulate emissions and should be further monitored during and after the introduction of the Euro 5 step. Moreover, including SPN in the range 10-23 nm increases emission levels by up to 2.4 times compared to SPN23, while volatile and semi-volatile particle numbers were even higher. Finally, cold engine operation was found to be a significant contributor on SPN23 emissions, especially for vehicles with lower overall emission levels. These results indicate that a specific particle number limit may be required for L-category to align emissions with passenger cars.
Related Concept Videos
Turnover Number and Catalytic Efficiency
Chymotrypsin is a pancreatic enzyme that breaks down proteins during digestion....
Internal Combustion Engine

