Related Experiment Video
Updated: Dec 31, 2025
Treatment with Locking Intramedullary Nailing for Intertrochanteric Fracture of the Femur Utilizing a New Awl with a Distal Positioner
Published on: June 6, 2025
Variables Associated With Lag Screw Sliding After Single-Screw Cephalomedullary Nail Fixation of Intertrochanteric
Joshua A Parry1, Travis Sapp2, Joshua R Langford3
1Department of Orthopaedics, Denver Health, University of Colorado School of Medicine, Denver, CO.
Objectives:
To evaluate variables associated with lag screw sliding after single-screw cephalomedullary nail (CMN) fixation of intertrochanteric femur fractures.
Design:
Retrospective cohort study.
Setting:
Level-one trauma center.
Patients/Participants:
One hundred fifty-eight intertrochanteric fractures in patients older than 65 years with an average follow-up of 22 months.
Intervention:
Single-screw CMN fixation.
Main Outcome Measurements:
Lag screw sliding and revision surgeries.
Results:
The average amount of lag screw sliding was 5 ± 5 mm (range, 0-21 mm). Lag screw sliding was greater with unstable fracture patterns (mean difference 2 mm, 95% confidence interval 0.4-3.5 mm, P = 0.01) and calcar gapping >4 mm (mean difference 3.7 mm, 95% confidence interval 2-5 mm, P < 0.01). No association was found between lag screw sliding and age, female gender, implants, long versus short nails, distal interlock screw use, postoperative neck-shaft angle, or tip-apex distance (P > 0.05). Revision surgeries were performed in 6 (4%) patients. Indications included symptomatic lag screw removal (n = 2), avascular necrosis (n = 1), cutout (n = 1), loss of reduction (n = 1), and perimplant fracture (n = 1).
Conclusions:
Unstable fracture patterns are unavoidable; however, careful attention to calcar reduction and selection of dual-screw CMN implants may minimize lag screw sliding and its detrimental effects on outcomes.
Level Of Evidence:
Prognostic Level III. See Instructions for Authors for a complete description of levels of evidence.
More Related Videos
04:19Minimally Invasive Treatment for Thoracolumbar Burst Fracture Using Sagittal Alignment Screws and A Trauma Reduction Device
Published on: November 8, 2024
07:41An Intramedullary Locking Nail for Standardized Fixation of Femur Osteotomies to Analyze Normal and Defective Bone Healing in Mice
Published on: November 13, 2016
Related Concept Videos
01:17Frictional Forces on Screws
A jack with a square-threaded screw is a mechanical device used to lift heavy loads by applying a force at its handle. When the force is applied, the screw turns, raising the load. The screw can...
01:16Self-Locking Screw
A square-threaded screw jack carrying a load is considered self-locking if the screw retains its position even after the moment applied to it is removed.
01:18Wood Fasteners
Nails are the most common fasteners, consisting of sharp-pointed metal pins that are driven into wood using a hammer or a mechanical nail gun. They come in a variety of diameters, heads, and lengths. Nailing techniques include...