Related Experiment Video
Updated: Dec 31, 2025

Protocol for Measuring the Thermal Properties of a Supercooled Synthetic Sand-water-gas-methane Hydrate Sample
Published on: March 21, 2016
Hydrophysical properties of sandy clay contaminated by petroleum hydrocarbon
Edyta Hewelke1, Dariusz Gozdowski2
1Water Centre WULS, Institute of Environmental Engineering, Warsaw University of Life Sciences, Nowoursynowska 166, 02-787, Warsaw, Poland. edyta_hewelke@sggw.pl.
Abstract:
The aim of the presented research was to assess the changes in hydro-physical properties of sandy clay under the influence of petroleum hydrocarbon contamination. An understanding of these changes is fundamental in the right remedial actions and for further use of soil. Laboratory tests of inherently wettable sandy clay showed that the petroleum hydrocarbon induced potential soil water repellency (SWR) of extremely repellent class at the contamination of 18 g kg-1. The relationship between soil water potential (pF) and SWR determined by the WDPT test for given hydrocarbon contamination, i.e., 6, 12, 18, 30, 100 g kg-1, showed that the critical soil moisture value (CSMC) corresponds to the pF = 1.0 ÷ 1.5. Soil retention characteristic (pF) showed that an increase in hydrocarbon contamination from 0 to 100 g kg-1 caused a reduction of total available water for plants from about 0.19 to 0.06 cm cm-3. At the same time, in the pF = 1.5 ÷ 2.0 range, intensive soil pore drainage was observed. Statistically, significant effect of hydrocarbon contamination and soil moisture potential on SWR was found. Soil hydrophobicity limits the addition of soil retention, because a significant part of the precipitation can be transformed by surface runoff. The carried out tests showed that at a hydrocarbon contamination of 30 g kg-1, total rainfall amount 14 mm with an intensity of 2 mm h-1 was transformed into a surface drain in approx. 40%. The conducted studies demonstrate the adverse impact of hydrocarbon contamination on the soil's hydro-physical properties. The soil water retention reduction and launching of the surface outflow, as a result of limiting the water penetration process resulting from SWR, change the agrohydrological conditions of the contaminated area. It can result as the imbalance of the flow of energy and matter in the ecosystem. The scenarios of environmental effects, among others, depend on the type of soil, the degree of its pollution, the type of ecosystem, and supporting activities undertaken by man. It should be taken into account that the increasing frequency of drought occurrence associated with climate change is conducive to the phenomenon of SWR regardless of the reasons for its occurrence.
More Related Videos
12:18Pore-scale Imaging and Characterization of Hydrocarbon Reservoir Rock Wettability at Subsurface Conditions Using X-ray Microtomography
Published on: October 21, 2018
08:17Chemical Analysis of Water-accommodated Fractions of Crude Oil Spills Using TIMS-FT-ICR MS
Published on: March 3, 2017
Related Concept Videos
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Entropy and Solvation
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Solubility
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules,...
Physical Properties of Alkanes
Intermolecular Forces and Physical Properties