I-Optimal design of poly(lactic-co-glycolic) acid/hydroxyapatite three-dimensional scaffolds produced by thermally...

In bone tissue engineering, 3D scaffolds are often designed to have adequate modulus while taking into consideration the requirement for a highly porous network for cell seeding and tissue growth. This paper presents the design optimization of 3D scaffolds made of poly(lactic-co-glycolic) acid (PLGA) and nanohydroxyapatite (nHA), produced by thermally induced phase separation (TIPS). Slow cooling at a rate of 1°C/min enabled a uniform temperature and produced porous scaffolds with a relatively uniform pore size. An I-optimal design of experiments (DoE) with 18 experimental runs was used to relate four responses (scaffold thickness, density, porosity, and modulus) to three experimental factors, namely the TIPS temperature (-20°C, -10°C, and 0°C), PLGA concentration (7%, 10%, and 13% w/v), and nHA content (0%, 15%, and 30% w/w). The response surface analysis using JMP^® software predicted a temperature of -18.3°C, a PLGA concentration of 10.3% w/v, and a nHA content of 30% w/w to achieve a thickness of 3 mm, a porosity of 83%, and a modulus of ~4 MPa. The set of validation scaffolds prepared using the predicted factor levels had a thickness of 3.05 ± 0.37 mm, a porosity of 86.8 ± 0.9 %, and a modulus of 3.57 ± 2.28 MPa.