Microstructural and Nanostructural Evolution of Light Harvester Perovskite Thin Film under the Influence of...

A key step of inexpensive and scalable perovskite thin-film formation is defect-free fabrication through low-cost and facile post-treatment processes. Methods using high annealing temperatures are not favorable for the scale-up of solution-processed thin-film solar cells, particularly on plastic/flexible substrates. This contribution analyzes the effect of ultrasonic vibrations, a recently developed low-cost post-treatment process, on thin-film quality. Ultrasonic vibrations were applied to as-spun CH₃NH₃PbI₃ perovskite thin films prepared with various solvents and antisolvents deposited on substrates with compact and mesoporous textures. Then, mechanisms of solvent evaporation, nucleation, and crystallization of perovskite grains were characterized during ultrasonic vibration. These studies demonstrate that ultrasonic vibration at low temperature facilitates heterogeneous crystallization of perovskite grains with a higher conversion of nuclei into crystal, compared with the conventional annealing process. Topographic scanning electron microscopy images confirm the dense and fully covered thin films after the evaporation of solvent. Furthermore, it is shown that crystal orientation does not change with the choice of solvent, eliminating the effect of solvent on the deposition of thin-film perovskites with this method. Therefore, this ultrasonic vibration post-treatment method is applicable to any solution-processed material and deposition technique, and it can be used to fabricate a range of thin-film devices and printed electronics.