Related Experiment Video
Updated: Dec 29, 2025

An Effective Inoculation Method for Phytophthora capsici on Black Pepper Plants
Published on: September 16, 2022
Decontamination of dried whole black peppercorns using ultraviolet-c irradiation
Alonzo A Gabriel1, Mikaella Marie C David1, Maxine Sebastianne C Elpa1
1Laboratory of Food Microbiology and Hygiene, Department of Food Science and Nutrition, College of Home Economics, Alonso Hall, Antonio Ma. Regidor St., University of the Philippines Diliman, Quezon City, 1101, Philippines.
Abstract:
This study determined the efficacy of UV-C as a decontamination process against some foodborne bacteria in dried whole black peppercorns. Artificially-inoculated Salmonella enterica, Escherichia coli O157:H7, Listeria monocytogenes, Pseudomonas aeruginosa, and Staphylococcus aureus were subjected to UV-C with a surface irradiance of 0.43 mW/cm2 and were all found to exhibit a biphasic inactivation pattern with fast log-linear inactivation followed by a tail. Total log reductions (TLR) ranged from 1.92 (S. aureus) to 3.60 log CFU/g (E. coli O157:H7). Increasing the lamp number from 1 to 5 also linearly (R2 = 0.98) increased the surface irradiance from 0.43 to 1.70 and the TLR of the most resistant S. aureus from 1.92 to 2.62 log CFU/g. Quality evaluation showed very small, variable changes in color coordinates, which were not detected by a same/different test involving a 50-member sensory evaluation panel. Mercury deposition was not detected after a maximum exposure time of 90 min to 0.43 and 1.70 mW/cm2. Finally small, non-significant changes in the innate bacterial microflora of the black peppercorns were determined after 90 min-treatment using 1 lamp and 5 lamps, emphasizing the limitation of utility of UV-C as additional decontamination process for post-process-introduced microorganisms. Good Manufacturing Practices throughout the dried black peppercorn manufacturing process were recommended.
More Related Videos
Related Concept Videos
Physical Methods for Controlling Microbial Growth: Radiation and Filtration
Methods of Sterilization II: Chemical Methods
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...
Methods of Sterilization I: Physical Methods
Steam sterilization uses non-toxic, low-cost moist heat in the form of saturated steam under pressure, which is fast, microbicidal, and sporicidal, and quickly warms and penetrates fabrics. Autoclaves, or steam sterilizers, expose each item to direct steam contact for a predetermined time at the necessary...

