Related Experiment Video
Updated: Dec 29, 2025

Characterization, Quantification and Compound-specific Isotopic Analysis of Pyrogenic Carbon Using Benzene Polycarboxylic Acids BPCA
Published on: May 16, 2016
No evidence for brown carbon formation in ambient particles undergoing atmospherically relevant drying
Vikram Pratap1, Michael A Battaglia1, Annmarie G Carlton2
1Department of Chemical, Biochemical and Environmental Engineering, University of Maryland, Baltimore County, USA. hennigan@umbc.edu.
Abstract:
Recent laboratory studies have reported the formation of light-absorbing organic carbon compounds (brown carbon, BrC) in particles undergoing drying. Atmospheric particles undergo cycles of humidification and drying during vertical transport and through daily variations in temperature and humidity, which implies particle drying could potentially be an important source of BrC globally. In this work, we investigated BrC formation in ambient particles undergoing drying at a site in the eastern United States during summer. Aerosol BrC concentrations were linked to secondary organic aerosol (SOA) formation, consistent with seasonal expectations for this region. Measurements of water-soluble organic aerosol concentrations and light absorption (365 nm) were alternated between an unperturbed channel and a channel that dried particles to 41% or 35% relative humidity (RH), depending on the system configuration. The RH maintained in the dry channels was below most ambient RH levels observed throughout the study. We did not observe BrC formation in particles that were dried to either RH level. The results were consistent across two summers, spanning ∼5 weeks of measurements that included a wide range of RH conditions and organic and inorganic aerosol loadings. This work suggests that mechanisms aside from humidification-drying cycles are more important contributors to ambient particle BrC loadings. The implications of this work on the atmospheric budget of BrC are discussed.
Related Concept Videos
The Carbon Cycle
Washing, Drying, and Ignition of Precipitates
Standard Enthalpy of Formation
Carbon-dioxide Fixation
The Sulfur Cycle
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...

