Technical and surgical causes of outliers after computer navigated total knee arthroplasty

Navigated total knee arthroplasty (TKA) improves implant and limb alignment but outliers continue to exist. This study aimed to determine the technical and surgical causes of outliers.

This retrospective cohort study included 208 patients who had undergone navigated TKA. Limb and implant alignment indices were measured on post-operative CT scans: mechanical femoro-tibial angle (MFTA); coronal femoral angle (CFA); coronal tibial angle (CTA); sagittal femoral angle (SFA); and sagittal tibial angle (STA). Values outside 0°±3° for MFTA and SFA, 90°±3° for CFA, CTA and STA were considered outliers. Intra-operative navigation data and CT scans were evaluated to categorize the causes of sagittal and coronal plane outliers into hip centre error; ankle centre error; heterogeneous tibial cement mantle; malalignment accepted by surgeon; suboptimal knee balance; and no obvious explanation.

Of the 1040 measurements (five per TKA), the overall incidence of outliers was 10.4% (n = 108). Femoral component outliers (CFA + SFA, n = 51) were all attributable to hip centre error. Tibial component outliers (CTA + STA, n = 43) were attributable to ankle centre error (n = 6), heterogeneous cement mantle (n = 20), malalignment accepted by the surgeon (n = 6) and no obvious cause (n = 11). MFTA outliers were attributable to hip centre error (n = 4) or suboptimal knee balance (n = 10).

Surgeon related errors can be minimized by a meticulous operative technique. These results indicate scope for additional technical improvement, especially in hip centre acquisition, which may further reduce the incidence of outliers.