Related Experiment Video
Updated: Dec 28, 2025
Creation of a High-Fidelity, Low-Cost, Intraosseous Line Placement Task Trainer via 3D Printing
Published on: August 17, 2022
Randomized Controlled Trial of the Effects of 3D-Printed Models and 3D Ultrasonography on Maternal-Fetal Attachment
Objective:
To determine whether the addition of 3D-printed models improves maternal-fetal attachment in healthy pregnancies more than 3D ultrasonography alone.
Design:
Randomized, parallel-group, controlled trial.
Setting:
University- and clinic system-affiliated locations in Omaha, Nebraska.
Participants:
Between May 2018 and February 2019, 857 pregnant women were screened for inclusion in the study, and 96 women (11%) were randomly assigned to an ultrasonography group (n = 48) or to an ultrasonography plus 3D-printed model group (n = 48).
Methods:
Participants completed the Maternal Antenatal Attachment Scale (MAAS) questionnaire before they received third trimester 3D ultrasonography. Participants were randomly allocated to receive 3D ultrasonography only or 3D ultrasonography plus 3D-printed models of the fetus's face. All participants completed a second MAAS questionnaire approximately 14 days after the study ultrasonography. The primary outcome was the global MAAS score. Secondary outcomes included the MAAS subscale scores.
Results:
The time-by-group interaction effect indicated that change in MAAS global score from baseline for the 3D-printed model group was 3.75 points greater than the score for the ultrasonography only group (95% confidence interval [1.40, 6.10], p = .002). Similar results were observed for the subscales with regard to quality of attachment and time spent thinking about the fetus.
Conclusions:
The use of fetal facial models resulted in greater increases in maternal-fetal attachment than the use of ultrasonography only. Future research into this new technology to enhance pregnancy outcomes is clearly warranted.
