Amplification of the chiroptical response of UV-transparent amines and alcohols by N-phthalimide derivatization

Daniele Padula1, Giuseppe Mazzeo, Ernesto Santoro

  • 1Dipartimento di Scienze, Università della Basilicata, via dell'Ateneo Lucano, 85100, Potenza, Italy. stefano.superchi@unibas.it.

Related Concept Videos

Preparation of 1° Amines: Gabriel Synthesis01:28

Preparation of 1° Amines: Gabriel Synthesis

Direct alkylation is not a suitable method for synthesizing amines because it produces polyalkylated products. Gabriel synthesis is the most preferred method to exclusively make primary amines. The method uses phthalimide, which contains a protected form of nitrogen that participates in alkylation only once to predominantly give primary amines.
Strong bases like NaOH or KOH deprotonate the phthalimide to form the corresponding anion, which acts as a nucleophile. Further, the anion attacks an...
4.4K
NMR Spectroscopy Of Amines01:19

NMR Spectroscopy Of Amines

In proton NMR spectroscopy, primary amines and secondary amines showcase their N–H protons as a broad signal in the chemical shift range between δ 0.5 and 5 ppm. The exact position in this range depends on several factors, including sample concentration, hydrogen bonding, and the type of solvent used. Since amine protons undergo fast proton exchange in solution, the protons are labile and therefore do not participate in any splitting with adjacent protons. Thus, the observed peak is...
10.7K
IR and UV–Vis Spectroscopy of Aldehydes and Ketones01:29

IR and UV–Vis Spectroscopy of Aldehydes and Ketones

Infrared spectroscopy, also known as vibrational spectroscopy, is mainly used to determine the types of bonds and functional groups in molecules. In aldehydes and ketones, the carbonyl (C=O) bond shows an absorption around 1710 cm-1. The C=O bond vibration of an aldehyde occurs at lower frequencies than that of a ketone. In addition to the C=O absorption in an aldehyde, the aldehydic C–H bond also gives two peaks in the 2700–2800 cm-1 range. This absorption, coupled with the...
7.2K
UV–Vis Spectroscopy: Woodward–Fieser Rules01:29

UV–Vis Spectroscopy: Woodward–Fieser Rules

UV–Visible absorption spectra of conjugated dienes arise from the lowest energy π → π* transitions. The light-absorbing part of the molecule is called the chromophore, and the substituents directly attached to the chromophore are called auxochromes. A strong correlation exists between the absorption maxima, λmax, and the structure of a conjugated π system. The Woodward–Fieser rules predict the value of λmax for a given structure by adding the...
27.9K
Amines to Amides: Acylation of Amines01:19

Amines to Amides: Acylation of Amines

Various carboxylic acid derivatives (such as acid chlorides, esters, and anhydrides) can be used for the acylation of amines to yield amides. The reaction requires two equivalents of amines. The first amine molecule functions as a nucleophile and attacks the carbonyl carbon to produce a tetrahedral intermediate. This is followed by the loss of the leaving group and restoration of the C=O bond.
Next, the second equivalent of amine serves as a Brønsted base and deprotonates the quaternary...
3.3K
Acid Halides to Amides: Aminolysis01:07

Acid Halides to Amides: Aminolysis

Aminolysis is a nucleophilic acyl substitution reaction, where ammonia or amines act as nucleophiles to give the substitution product. Acid halides react with ammonia, primary amines, and secondary amines to yield primary, secondary, and tertiary amides, respectively.
In the first step of the aminolysis mechanism, the amine attacks the carbonyl carbon of the acyl chloride to form a tetrahedral intermediate. In the second step, the carbonyl group is re-formed with the elimination of a chloride...
4.0K