Related Experiment Video

Updated: Dec 27, 2025

Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters
15:25

Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters

Published on: February 4, 2018

6.5K

Active narrowband filter based on inductance and capacitance for low-frequency applications

A Burd1, M Suchenek2

  • 1Institute of Electronic Systems, Warsaw University of Technology, Nowowiejska 15/19, 00665 Warsaw, Poland.

The Review of Scientific Instruments
|March 2, 2020
PubMed

More Related Videos

X-ray Beam Induced Current Measurements for Multi-Modal X-ray Microscopy of Solar Cells10:16

X-ray Beam Induced Current Measurements for Multi-Modal X-ray Microscopy of Solar Cells

Published on: August 20, 2019

14.3K
Fabrication and Characterization of Superconducting Resonators10:26

Fabrication and Characterization of Superconducting Resonators

Published on: May 21, 2016

11.8K

Related Concept Videos

Passive Filters01:27

Passive Filters

Passive filters are utilized to shape the frequency spectrum of signals across a diverse array of applications. These filters, using only passive elements like resistors (R), inductors (L), and capacitors (C), are capable of selectively allowing or blocking certain frequency ranges without the need for external power sources.
Low-Pass Filters
Low-pass filters are designed to transmit signals with frequencies lower than the cutoff frequency, ωc, and attenuate those above it. The cutoff...
906
Active Filters01:25

Active Filters

Active filters are electronic circuits that use operational amplifiers (op-amps), resistors, and capacitors to filter out unwanted frequency components from a signal. A first-order low-pass active filter is designed to pass signals with a frequency lower than a certain cutoff frequency and attenuate frequencies higher than that cutoff frequency. The transfer function for a first-order low-pass active filter is:
1.2K
Parallel Resonance01:23

Parallel Resonance

The parallel RLC circuit is an arrangement where the resistor (R), inductor (L), and capacitor (C) are all connected to the same nodes and, as a result, share the same voltage across them. The parallel RLC circuit is analyzed in terms of admittance (Y), which reflects the ease with which current can flow. The admittance is given by:
451
Inductors01:11

Inductors

An inductor is a passive component built to store energy within its magnetic field. It can be fabricated by coiling a wire around a magnetic core. When current is permitted to flow through this inductor, it is observed that the voltage across the inductor is directly proportional to the time rate of change of the current. Mathematically,
846
Inductors01:20

Inductors

An inductor, also known as a choke, is a circuit component created to have a specific inductance. Inductors are among the crucial circuit components used in modern electronics, along with resistors and capacitors. They serve as a barrier against changes in a circuit's current. An inductor tends to suppress current changes in an alternating-current circuit that are faster than desired. In a direct-current circuit, an inductor aids in preserving a constant current despite changes in the...
5.9K
Characteristics of Series Resonant Circuit01:24

Characteristics of Series Resonant Circuit

Series resonance occurs in a circuit containing inductive (L), capacitive (C), and resistive (R) elements connected sequentially. At the resonance frequency, the inductive and capacitive reactances are equal in magnitude but opposite in sign, effectively canceling each other. This causes the circuit's impedance is minimal, primarily determined by the resistance R. The resonant frequency of an RLC circuit is defined as:
498