Related Experiment Video
Updated: Dec 27, 2025

Ohmic Contact Fabrication Using a Focused-ion Beam Technique and Electrical Characterization for Layer Semiconductor Nanostructures
Published on: December 5, 2015
Thickness-Independent Semiconducting-to-Metallic Conversion in Wafer-Scale Two-Dimensional PtSe2 Layers by
Mashiyat Sumaiya Shawkat1,2, Jaeyoung Gil3, Sang Sub Han1,4
1NanoScience Technology Center, University of Central Florida, Orlando, Florida 32826, United States.
Abstract:
Platinum diselenide (PtSe2) is an emerging class of two-dimensional (2D) transition-metal dichalcogenide (TMD) crystals recently gaining substantial interest, owing to its extraordinary properties absent in conventional 2D TMD layers. Most interestingly, it exhibits a thickness-dependent semiconducting-to-metallic transition, i.e., thick 2D PtSe2 layers, which are intrinsically metallic, become semiconducting with their thickness reduced below a certain point. Realizing both semiconducting and metallic phases within identical 2D PtSe2 layers in a spatially well-controlled manner offers unprecedented opportunities toward atomically thin tailored electronic junctions, unattainable with conventional materials. In this study, beyond this thickness-dependent intrinsic semiconducting-to-metallic transition of 2D PtSe2 layers, we demonstrate that controlled plasma irradiation can "externally" achieve such tunable carrier transports. We grew wafer-scale very thin (a few nm) 2D PtSe2 layers by a chemical vapor deposition (CVD) method and confirmed their intrinsic semiconducting properties. We then irradiated the material with argon (Ar) plasma, which was intended to make it more semiconducting by thickness reduction. Surprisingly, we discovered a reversed transition of semiconducting to metallic, which is opposite to the prediction concerning their intrinsic thickness-dependent carrier transports. Through extensive structural and chemical characterization, we identified that the plasma irradiation introduces a large concentration of near-atomic defects and selenium (Se) vacancies in initially stoichiometric 2D PtSe2 layers. Furthermore, we performed density functional theory (DFT) calculations and clarified that the band-gap energy of such defective 2D PtSe2 layers gradually decreases with increasing defect concentration and dimensions, accompanying a large number of midgap energy states. This corroborative experimental and theoretical study decisively verifies the fundamental mechanism for this externally controlled semiconducting-to-metallic transition in large-area CVD-grown 2D PtSe2 layers, greatly broadening their versatility for futuristic electronics.
More Related Videos
08:50Preparation of Large-area Vertical 2D Crystal Hetero-structures Through the Sulfurization of Transition Metal Films for Device Fabrication
Published on: November 28, 2017
06:57Theoretical Calculation and Experimental Verification for Dislocation Reduction in Germanium Epitaxial Layers with Semicylindrical Voids on Silicon
Published on: July 17, 2020