Simulation and Training of Needle Puncture Procedure with a Patient-Specific 3D Printed Gluteal Artery Model

The puncture of the gluteal artery (GA) is a rare and difficult procedure. Less experienced clinicians do not always have the opportunity to practice and prepare for it, which creates a need for novel training tools. We aimed to investigate the feasibility of developing a 3D-printed, patient-specific phantom of the GA and its surrounding tissues to determine the extent to which the model can be used as an aid in needle puncture planning, simulation, and training. Computed tomography angiography scans of a patient with an endoleak to an internal iliac artery aneurysm with no intravascular antegrade access were processed. The arterial system, including the superior GA with its division branches, and pelvic area bones were 3D printed. The 3D model was embedded in the buttocks-shaped, patient-specific mold and cast. The manufactured, life-sized phantom was used to simulate the GA puncture procedure and was validated by 13 endovascular specialists. The printed GA was visible in the fluoroscopy, allowing for a needle puncture procedure simulation. The contrast medium was administered, simulating a digital subtraction angiography. Participating doctors suggested that the model could make a significant impact on preprocedural planning and resident training programs. Although the results are promising, we recommend that further studies be used to adjust the design and assess its clinical value.