Related Experiment Video
Updated: Dec 26, 2025

A Protocol for Conducting Rainfall Simulation to Study Soil Runoff
Published on: April 3, 2014
Erosion characteristics of different reclaimed substrates on iron tailings slopes under simulated rainfall
Chunjuan Lv1, Rutian Bi2, Xingxing Guo2
1College of Resources and Environment, National Experimental Teaching Demonstration Center, Shanxi Agricultural University, Taigu, Shanxi, 030801, China. lcjcwg@126.com.
Abstract:
Water-induced erosion of iron tailings is a serious problem affecting ecological restoration, but, little is known about how the occurrence of erosion on tailings slopes and types of reclaimed substrates that are beneficial to reducing slope erosion. This study measured the slope erosion characteristics of six reclaimed substrates including loose tailings (LT), crusty tailings (CT), tailings incorporating mushroom residues (TM), tailings incorporating soil (TS), tailings incorporating soil and mushroom residues (TSM) and soil (S) in experimental soil flumes under three simulated intermittent rainfall events, with intensity of 60, 90 and 120 mm h-1 for the first, second and third event, respectively. Significant differences (p < 0.05) were found in erosion characteristics among the six reclaimed substrates. TM had the lowest sediment yield but the highest runoff volume without obvious rills. LT, CT and TS had the highest sediment yield rates and severe slope erosion morphology. With the increased number of rainfall events, the runoff rates of the six substrates all increased, but only the sediment yield rates of LT, CT and TS increased, the sediment yield rates of other substrates increased first and then decreased. Therefore, adding agricultural organic wastes such as mushroom residues to tailings and reducing soil addition may be an effective way to reduce erosion and promote ecological restoration in soilless tailings areas.
Related Concept Videos
Abrasion Resistance of Concrete
One such test is the revolving disc test, where three plates...
Toughness and Hardness of Aggregate
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Design Example: Design of an Irrigation Channel
Corrosion of Reinforcement
However, over time and under certain conditions like carbonation, chloride ingress, and cracking this protective state can be compromised. Steel has areas with...
Precipitation and Co-precipitation

