Wafer-scale nanofabrication of sub-100 nm arrays by deep-UV displacement Talbot lithography

In this manuscript, we demonstrate the potential of replacing the standard bottom anti-reflective coating (BARC) with a polymethylglutarimide (PMGI) layer for wafer-scale nanofabrication by means of deep-UV displacement talbot lithography (DTL). PMGI is functioning as a developable non-UV sensitive bottom anti-reflective coating (DBARC). After introducing the fabrication process using a standard BARC-based coating and the novel PMGI-based one, the DTL nanopatterning capabilities for both coatings are compared by means of the fabrication of etched nanoholes in a dielectric layer and metal nanodots made by lift-off. Improvement of DTL capabilities are attributed to a reduction of process complexity by avoiding the use of O₂ plasma etching of the BARC layer. We show the capacity of this approach to produce nanoholes or nanodots with diameters ranging from 95 to 200 nm at a wafer-scale using only one mask and a proper exposing dose. The minimum diameter of the nanoholes is reduced from 118 to 95 nm when using the PMGI-based coating instead of the BARC-based one. The possibilities opened by the PMGI-based coating are illustrated by the successful fabrication of an array of nanoholes with sub-100 nm diameter for GaAs nanowire growth on a 2″ GaAs wafer, a 2″ nanoimprint lithography (NIL) master stamp, and an array of Au nanodots made by lift-off on a 4″ silica wafer. Therefore, DTL possess the potential for wafer-scale manufacturing of nano-engineered materials.