Related Experiment Video
Updated: Dec 24, 2025

Self-Nanoemulsification of Healthy Oils to Enhance the Solubility of Lipophilic Drugs
Published on: July 27, 2022
Effect of the concentration and size of suspended particulate matter on oil-particle aggregation
Zhixin Qi1, Yue Yu1, Xinping Yu1
1College of Environmental Sciences and Engineering, Dalian Maritime University, Dalian 116026, China.
Abstract:
After spill, the dispersed oil droplets may collide with suspended particulate matter in the water column to form oil-particle aggregates (OPAs) in turbulent environments. It may be an effective pathway to stabilize the oil by taking advantage of the particulate matter to clean up the contaminated waters. A theoretical model in Payne et al. (2003) is adopted to describe the oil-particle aggregation, and a solution method is proposed and validated against a group of experiments. The effect of the particle size and mass concentration on the aggregation has been examined quantitatively in detail. The particles and the oil droplets are consumed at a fixed ratio. Under the same mass concentration, smaller particles can trap more oil droplets, while larger particles tend to interact more quickly with the oil. The oil-particle aggregation rate and the oil trapping efficiency mainly depend on the particle concentration. The theoretical model is applied to predict the decrease of the dispersed oil in nearshore environments, based on the parameters obtained from the experiments. It is efficient to promote the oil-particle aggregation by increasing the particle concentration in the closed bay. In the open sea, the decrease of the dispersed oil can be effectively enhanced by increasing the particle concentration when it is below 0.50 kg/m3. The information presented in this paper can serve to predict the fate of the dispersed oil in coastal waters and provide technical support for oil spill management strategies.
Related Concept Videos
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
Colloidal precipitates
Factors Affecting Dissolution: Particle Size and Effective Surface Area
Colloids
Colloids and Suspensions
Coagulation

