Computational Comparison between the Altura Aortic Endograft Configuration and the Classic Bifurcated Idealized...

The Altura (Alt) endograft is a new design, lacking the classic main body with the flow divider. Instead, 2 proximal D-shaped endografts form a round circumference in the aortic neck for secure sealing and land in the iliac arteries in a cross-limb fashion. The aim of this computational study was to compare hemodynamically this model with the classic bifurcated (Bif) and cross-limb (Cx) endograft designs of equal total length.

All 3D endograft models were created using the finite volume analysis application ANSYS CFX (Ansys Inc., Canonsburg, PA, USA). The Alt inlet was constructed as 2 opposing D-shaped sections. The flow was quantified by time-averaged wall shear stress (TAWSS), oscillatory shear index (OSI), relative residence time (RRT), and helicity. The displacement forces were also compared for all models with computational fluid dynamics analysis.

The Alt design was associated with lower forces (range 4.0-5.9Ν) than Bif (4.17-6.15 N) and Cx (4.43-6.53 N). The 2-piece inlet site of the separated limbs of Alt has higher TAWSS than the uniform inlet segment of the Cx and the Bif model. Most importantly, the mid-segment and distal segment of the limbs in the Alt design present higher TAWSS in a greater area than the other 2 models. The inlet of the Alt design showed higher OSI than the other accommodations and similar or comparable OSI values along their mid-limb and distal limb segments. The range, location, and values or RRT were comparable between the 3 models. Helicity in the iliac limbs is more prominent in the crossed accommodations (Alt and Cx).

Only small differences in the hemodynamic indices and displacement forces were detected between the Alt and classic accommodations. From this point of view, the Alt design could be theoretically considered not inferior to other widely used endograft configurations.