Related Experiment Video
Updated: Dec 21, 2025
Digital Hybrid Model Preparation for Virtual Planning of Reconstructive Dentoalveolar Surgical Procedures
Published on: August 5, 2021
Validation of a three-dimensional printed model for training of surgical extraction of supernumerary teeth
Yong Kwon Chae1, Hyeonjong Lee2, Myeong Kwan Jih3
1Department of Pediatric Dentistry, School of Dentistry, Kyung Hee University, Seoul, Korea.
Introduction:
This study aimed to validate a three-dimensional (3D) printed model to provide training for supernumerary teeth (SNTs) extraction.
Materials And Methods:
Each of the 30 participants, grouped as experienced and without experience, conducted two identically simulated surgeries on a 3D-printed replica of human mixed dentition with a SNT. The surgery time, area of bony window and volume of removed material were measured; subsequently, responses to a five-item questionnaire were recorded. The collected data were statistically analysed.
Results:
The surgery time was 228.37 ± 141.53 seconds and 125.47 ± 53.03 seconds in the first and second surgery, respectively. The training significantly decreased the surgery time in the participants without experience (P = .000). However, there were no significant differences in the area of window opening (P = .271) and volume of removed material between the two surgeries (P = .075). The participants who perceived educational benefits accounted for more than 60% of the respondents for every question. Participants without experience in SNT extraction showed a tendency to rate a higher score than did those with experience.
Conclusions:
A 3D-printed model for surgical extraction of a SNT can improve surgical skill and, especially, shorten the learning curve in beginners.
