Related Experiment Video
Updated: Dec 21, 2025

Patch-clamp Capacitance Measurements and Ca2+ Imaging at Single Nerve Terminals in Retinal Slices
Published on: January 19, 2012
A new simple approach to estimation of membrane capacitance from current responses to voltage clamp steps
Jiří Šimurda1, Milena Šimurdová1, Olga Švecová1
1Department of Physiology, Medical Faculty, Masaryk University Brno, Czech Republic.
Abstract:
A variety of techniques of cell capacitance measurement have been proposed and applied in cellular electrophysiology. They are mostly based on the evaluation of membrane current responses to small changes in the membrane voltage. One of the currently used approaches applies the least-squares fit of an exponential current decay in response to voltage clamped rectangular pulses. In this study, we propose an alternative simpler approach to evaluation of the exponential parts in the current responses to square wave stimulation and present preliminary results of membrane capacitance evaluation. It is based on the property of the exponential function that has not yet been used to measure membrane capacitance. The time constant and the asymptote of the exponential waveform are unambiguously determined by the values read at three points separated by a constant time interval. In order to minimize the effect of noise and deviations from the exponential waveform, the triplet of points is designed to slide along the time axis. The results of the proposed approach and those previously evaluated by the least squares method are comparable. The method described may be advantageous for continuously recording changes in membrane capacitance.
Related Concept Videos
Patch Clamp
In this method, a glass micropipette containing electrolyte solution is tightly sealed against a small portion of the cell membrane. As a result, a patch of the cell...
Potentiometry: Membrane Electrodes
RC Circuit with Source
Due to the inherent properties of a capacitor, its voltage cannot change instantaneously. This means that immediately after the switch is closed, the capacitor's voltage remains the same as it was just before the switch was closed.
Ampere-Maxwell's Law: Problem-Solving
To solve the problem, we can use the equations from the analysis of an RC circuit and Maxwell's version of Ampère's law.
For the first part of the...
Design Example: Capacitance Multiplier Circuit
The circuit illustrated in Figure 1 below incorporates two op-amps, with the first operating as a voltage follower and the second acting as an inverting amplifier.
Resting Membrane Potential
The Inside of a Neuron is More Negative
The membrane potential of a cell can be measured by inserting a microelectrode into a cell and comparing the charge to a reference electrode in the extracellular fluid. The...

