Viscosity of API/fatty acid suspensions: Pitfalls during analysis

This article describes how to obtain reliable data during rheological analysis of active pharmaceutical ingredient/fatty acid suspensions. These materials are specifically used for prilling, an innovative pharmaceutical technique for the production of a multiparticulate dosage form. Nevertheless, presented guidelines are applicable for a wide range of pharmaceutical suspensions. Reliable rheological results can only be obtained when being aware of artefacts, such as a non-continuous medium, sedimentation, apparent wall slip and protrusion flow. To comply with the continuum hypothesis at high phase volumes (≥25% w/w), the required gap-to-particle-size ratio may be larger than the generally accepted 10:1 ratio. Reproducible flow curves that are not disturbed by sedimentation during sample analysis can be obtained faster by varying the shear rate stepwise from high to low values. While apparent wall slip (at low shear rates) can be prevented via serrated instead of smooth plates, protrusion flow (at high shear rates) during measurements with serrated plates results in non-reliable data. Therefore, in general, high viscous suspensions with yield stress can be analysed with serrated plates, while low viscous suspensions without yield stress should be analysed with geometries having smooth surfaces. By following these guidelines, accurate rheological properties of pharmaceutical suspensions can be obtained.