Related Experiment Video
Updated: Dec 20, 2025
High-Resolution Cardiac Positron Emission Tomography/Computed Tomography for Small Animals
Published on: December 16, 2022
Validation of regional myocardial blood flow quantification using three-dimensional PET with rubidium-82:
Osamu Manabe1, Ran Klein2, Chietsugu Katoh3
1Department of Diagnostic Imaging, Hokkaido University Hospital, Sapporo, Japan.
Introduction:
Three-dimensional (3D) data acquisition is now standard on PET/computed tomography scanners. The aim of this study was to evaluate the repeatability of myocardial blood flow (MBF) estimation with rubidium-82 (Rb) 3D PET and to validate regional MBF measurements by comparison with two-dimensional (2D) PET.
Patients And Methods:
Fifteen healthy individuals (31.6 ± 11.4 years old) were enrolled for the evaluation of the short-term repeatability of rest 3D MBF quantification. Another 19 healthy individuals (35.3 ± 12.6 years old) underwent rest and pharmacological stress PET using 2D and 3D data acquisition within a 1-month interval. The injected dose was 1500 MBq for 2D and 555 MBq for 3D PET acquisition.
Results:
MBF at rest showed good repeatability [whole left ventricular MBF; 0.54 ± 0.13 vs. 0.52 ± 0.13 mL/min/g, P = 0.98]. Rest MBF, stress MBF, and myocardial flow reserve (MFR) were not significantly different between 3D and 2D data acquisition. 3D MBF correlated well with 2D MBF over a wide flow range for both whole left ventricular (r = 0.97, P < 0.0001) and regional values (r = 0.61, P < 0.0001).
Conclusion:
MBF measured with 3D PET showed very good test-retest repeatability. Whole left ventricular and regional MBF measurements obtained using lower Rb-dose 3D PET were highly correlated over a wide range with those from 2D PET. Therefore, MBF with 3D PET can be applied using a lower Rb dosage in clinical settings with reduced radiation exposure.
