Related Experiment Video
Updated: Dec 19, 2025

Two-way Valorization of Blast Furnace Slag: Synthesis of Precipitated Calcium Carbonate and Zeolitic Heavy Metal Adsorbent
Published on: February 21, 2017
Recovery of phosphorus from municipal wastewater treatment sludge through bioleaching using Acidithiobacillus
YuJin Lee1, Manivannan Sethurajan2, Jack van de Vossenberg2
1Department of Environmental Engineering and Water Technology, IHE Delft Institute for Water Education, PO Box 3015, 2601, DA Delft, the Netherlands; Laboratory of Analytical Chemistry and Applied Ecochemistry, Department of Green Chemistry and Technology, Ghent University, Coupure Links 653, B-9000, Gent, Belgium.
Abstract:
Conventional wastewater treatment plants remove phosphorus, which is captured in sewage sludge. Increasing attention is paid to suitable process pathways that allow recovery and recycling of phosphorus. One of the processes under investigation is acid leaching and recovery of phosphorus, but this requires considerable chemical additives, which could be avoided by stimulating acidification via microbiological processes. This study investigated phosphorus leaching from sewage sludge by biogenic sulfuric acid, using Acidithiobacillus thiooxidans. Sulfur supplementation and solid to liquid ratio were varied to examine how these factors affected phosphorus leaching yield. Chemical leaching by sulfuric acid from sewage sludge and thermally-treated sludge was conducted to compare with bioleaching from sewage sludge. Sewage sludge samples were collected from wastewater treatment plants in Ghent, Belgium, and Delft, The Netherlands. Both bioleaching and chemical leaching were conducted at laboratory scale using shake flask technique, and highest phosphorus leaching yield and time was determined using one-way ANOVA statistical tests. Biogenic sulfuric acid produced by A. thiooxidans extracted phosphorus from both sludge samples. The highest phosphorus leaching yield observed was 48 ± 0% for 17 days from Ghent samples and 57 ± 4% for 27 days from Delft samples with 5.0% (w/v) sulfur supplementation and 1.0% (w/v) solid to liquid ratio. Chemical leaching took shorter than bioleaching, but the leaching yield was lower, i.e. 41 ± 1% for 4 h from Ghent samples, 44 ± 1% for 1 h from Delft samples, 48 ± 1% for 1 h from thermally-treated Ghent samples and 51 ± 2% for 4 h from thermally-treated Delft samples. During phosphorus bioleaching, pH increase was observed during the early stage which hampered the activity of A. thiooxidans and therefore increased phosphorus leaching time. This study suggests that creating conditions for A. thiooxidans to overcome acid neutralizing capacity of sewage sludge is needed to extract phosphorus effectively.
More Related Videos
15:19Development of Sulfidogenic Sludge from Marine Sediments and Trichloroethylene Reduction in an Upflow Anaerobic Sludge Blanket Reactor
Published on: October 15, 2015
06:11Author Spotlight: Advancing Anaerobic Microbiota Research Using a Novel Respirometry Protocol
Published on: April 26, 2024
Related Concept Videos
Factors Affecting Solubility
Bioremediation
Metabolism of Chemolithotrophs