Facile modification of graphene oxide and its application for the aqueous uranyl ion sequestration: Insights on the
Jin Wang1, Fa Fang2, Yuchen Zhou2
1School of Environmental Science and Engineering, Guangzhou University, Guangzhou, 510006, China; Guangdong Provincial Key Laboratory of Radionuclides Pollution Control and Resources, Guangzhou, 510006, China.
Abstract:
Graphene oxide (GO) has been proved with favorable affinity to U(VI), while some drawbacks such as poor dispersity and low adsorption performance limit its application. Herein, cetyltrimethylammonium bromide (CTAB) modified graphene oxide (MGO) composites were successfully fabricated, characterized and compared with graphene oxide (GO) in the sequestration of U(VI) in aqueous solutions. The results showed that maximum adsorption rate of MGO (99.21%) was obviously higher than that of GO (66.51%) under the same initial condition. Simultaneous introduction of C-H and NO coupled with the enhanced dispersity of GO after modification were mainly responsible for the updated performance verified with multiple characterization techniques. Based on the results of kinetics and isotherms investigations, the experimental data were best described by Pseudo-first-order kinetic model and Redlich-Peterson isotherm model. The results of ΔH, ΔS and ΔG show that adsorptive behaviors of uranyl ion on MGO are endothermic and spontaneous. The study provides a feasible alternative to the chemical modification of GO and enhancing the performance towards uranyl ion removal from solution.
More Related Videos
09:23Removal of Trace Elements by Cupric Oxide Nanoparticles from Uranium In Situ Recovery Bleed Water and Its Effect on Cell Viability
Published on: June 21, 2015
09:15Iridium Oxide-reduced Graphene Oxide Nanohybrid Thin Film Modified Screen-printed Electrodes as Disposable Electrochemical Paper Microfluidic pH Sensors
Published on: November 22, 2016
