Parametric Optimization of Laser Additive Manufacturing of Inconel 625 Using Taguchi Method and Grey Relational...

In order to improve the forming quality of the Inconel 625 cladding layer and make it to be more widely used. This paper addresses an experimental investigation on the influence of major process parameters like laser power, scanning speed, powder feed rate, and overlapping rate along with their interactions on surface roughness and width error of laser additive manufacturing process for forming Inconel 625 samples. Taguchi method and grey relational analysis were used to optimize the selected parameters, and the verification tests were carried out. The change of microhardness and microstructure in the overlapping zone and nonoverlapping zone of the cladding layer were studied by microhardness tester and scanning electron microscopy (SEM). The results show that the most significant effect in processing parameters on surface roughness and width error are both overlapping rate, and the optimal levels of laser power, scanning speed, powder feeder rate, and overlapping rate are 1800 W, 8 mm/s, 10 g/min, and 30%, respectively. Analysis of microstructure and composition showed that the content of Cr was high both in the Laves phase and matrix, the content of Nb in the Laves phase increased significantly and reached up to 24.48 wt%, and the Laves in the nonoverlapping zone was more compact than the overlapping zone.