The effect of laser sintering on the microstructure, relative density, and cracking of sol-gel-derived silica thin...

Combining sol-gel processing and laser sintering is a promising way for fabricating functional ceramic deposition with high dimensional resolution. In this work, crack-free silica tracks on a silica substrate with a thickness from ~360 nm to ~950 nm, have been obtained by direct exposure to a CO₂ laser beam. At a fixed scanning speed, the density and microstructures of the silica deposition can be precisely controlled by varying the laser output power. The porosity of the laser-sintered silica tracks ranged from close to 0% to ~60%. When the thickness of the silica deposition exceeded the critical thickness (eg, ~2.2 μm before firing), cracks occurred in both laser-sintered and furnace-sintered samples. Cracks propagated along the edge of the laser-sintered track, resulting in the crack-free track. However, for the furnace heat-treated counterpart, the cracks spread randomly. To understand the laser sintering effect, we established a finite element model (FEM) to calculate the temperature profile of the substrate during laser scanning, which agreed well with the one-dimensional analytical model. The FEM model confirmed that laser sintering was the main thermal effect and the calculated temperature profile can be used to predict the microstructure of the laser-sintered tracks. Combining these results, we were able to fabricate, predesigned patterned (Clemson tiger paw) silica films with high density using a galvo scanner.