Citations and altmetrics attention scores: tweets matter

Once data is collected from both the experimental and the control groups, a statistical analysis is conducted to find out if there are meaningful differences between the two groups. A statistical analysis determines how likely any difference found is due to chance (and thus not meaningful). In psychology, group differences are considered meaningful, or significant, if the odds that these differences occurred by chance alone are 5 percent or less. Stated another way, if we repeated this...

The z score is one of the three measures of relative standing. It describes the location of a value in a dataset relative to the mean. z scores are obtained after the standardization of the values in a dataset. The z score for the mean is 0.
 This score indicates how far a value is from the mean in terms of standard deviation. For example, if a data value has a z score of +1, the researcher can infer that the particular data value is one standard deviation above the mean. If another data...

In an electrical system with a resistor, voltage and current signals facilitate the measurement of power and energy across the resistor. For a continuous-time signal, the total energy over a time interval is defined as the integral of the square of the signal's magnitude over that interval. Mathematically, this is expressed as:

When we take repeated measurements on the same or replicated samples, we will observe inconsistencies in the magnitude. These inconsistencies are called errors. To categorize and characterize these results and their errors, the researcher can use statistical analysis to determine the quality of the measurements and/or suitability of the methods.
One of the most commonly used statistical quantifiers is the mean, which is the ratio between the sum of the numerical values of all results and the...

A bar graph is also called a bar chart and consists of bars that are separated from each other. It either uses horizontal or vertical bars to show comparisons among categories. The bars can be rectangles, or they can be rectangular boxes (used in three-dimensional plots). One axis of the graph represents the specific categories being compared, and the other axis shows a discrete value. In this graph, the length of the bar for each category is proportional to the number or percent of individuals...

The "center" of a data set is also a way of describing location. The two most widely used measures of the "center" of the data are the mean (average) and the median. The words "mean" and "average" are often used interchangeably. The substitution of one word for the other is common practice. The technical term is "arithmetic mean" and "average" is technically a center location. However, in practice among non-statisticians,...