Physical and chemical characterization of shock-induced cavitation

A strong impact on a water surface induces a shock wave propagation with a significant pressure variation leading to cavitation bubble formation. A new shock induced cavitation reactor described in this work was characterized by physical and chemical techniques. Water hammer model verification with Joukowsky approach allowed to determine the wave speed propagation and gas fraction in water submitted to shock. These values were used for frequency analysis and compared with direct bubble visualization in order to estimate the influence of the experimental parameters on the shock-induced cavitation. Thereby, the shock wave contains a broad spectrum as decomposed into frequencies. This multi-frequency nature induces heterogeneous bubbles with calculated radii of 0.01 to 3.5 mm and observed radii of 0.01 to 2.8 mm depending on experimental conditions (initial pressure, impact height, gas atmosphere). For the first time, the formation of hydroxyl radicals was proven under impact-induced cavitation. The concentration of radicals increases with increasing number of successive impacts, reaching ca. 1.3 µmol.L^-1 after 500 impacts in the presence of 20% O₂-Ar as saturating gas. Radical generation seems to be relatively independent of the impact height but strongly depend on the type of gas saturating water, being substantially lower in the presence of air. Moreover, radical generation increases when decreasing the initial pressure and depends on the frequency at which water is impacted by the piston. Nevertheless, yield of OH radicals during shock-induced cavitation remains much lower than that produced by power ultrasound.