Related Experiment Video
Updated: Dec 13, 2025

Pulse Wave Velocity Testing in the Baltimore Longitudinal Study of Aging
Published on: February 7, 2014
Feasibility of Non-invasive Pulse Pressure Measurement Using the Phased-Tracking Method
Shusaku Kobori1, Jun Murotsuki2, Shimpei Watanabe3
1Department of Obstetrics and Gynecology, Tohoku University, Sendai, Miyagi, Japan.
Abstract:
Phased tracking (PT) is a high-precision ultrasonic technology that enables measurements of pulse pressure (PP). The aim of this study was to verify the accuracy of estimated PP using PT. Estimated PPs were compared with measured PPs in three sheep fetuses that were connected to an artificial placenta system. Similarly, estimated and measured PPs of 30 human neonates were compared. PP was calculated using the Water-Hammer equation (PP = ρ × PWV (pulse wave velocity) × ΔU). PWV was estimated by measuring the transit times of pulse waves at two sites along the aorta using the PT method, and ΔU was obtained by subtracting end-diastolic velocity from peak systolic velocity. The correlation between the estimated and measured PPs of the sheep fetuses was strong (r = 0.95, p ˂ 0.01), as was the case with the human neonates (r = 0.88, p ˂ 0.05). It can be concluded from the results of this study that PT may be a non-invasive alternative method used to predict PP.
Related Concept Videos
Sites for measruring blood pressure
The Brachial Artery: Primary Site for Blood Pressure Measurement
Assessment of blood pressure in brachial artery(two-step method)
Equipments Used To Measure Blood Pressure
This invasive approach involves cannulating a peripheral artery. During each cardiac contraction, pressure generates mechanical motion within the catheter, transmitted through rigid, fluid-filled tubing to a transducer. This transducer converts mechanical motion into electrical signals displayed as waveforms on a monitor. An automatic flushing system prevents blood backflow. Due to the potential risk of unexpected arterial blood loss, this method is primarily used in intensive...
Special considerations while measuring blood pressure
Monitoring Both Arms:
Monitoring BP in both arms during the initial assessment is advisable, as the systolic value may differ by five to ten mm Hg between arms. For subsequent BP assessments, use the arm with the higher reading.
Assessing Blood pressure using a doppler ultrasound
Pre-Procedural Guidelines for Doppler Ultrasound Blood Pressure Assessment:
Preparation of Equipment:
Measurement of Blood Pressure

