Investigation on the variations of sludge water holding capacity of electro-dewatering process

Since the effect of electro-dewatering (EDW) on sludge water holding capacity was unknown, tests were conducted in this study to investigate the water holding capacity of EDW sludge and the potential mechanism related to the sludge physicochemical characteristics, EPS properties and sludge structure. Sludge was dewatered to the average moisture content (AMC) of 80%, 70% and 60% with different applied voltages at 20, 30 and 40V in EDW, respectively. Then the dewatered sludge near the anode and cathode were rewatered. The variation of sludge water holding capacity in EDW process was evaluated in terms of filterability and saturated moisture content (SMC), and the filterability was assessed by the specific resistance to filtration (SRF) of rewatered sludge. The results indicated that SRF of rewatered sludge near the cathode increased greatly. The proteins/polysaccharides (PN/PS) of loosely bound extracellular polymeric substances (LB-EPS) was significantly positively correlated with SRF (r = 0.891, p < 0.01). Moreover, the exposure of hydrophobic sites or groups in PN near the cathode improved the surface hydrophobicity of sludge, which reduced the filterability. In addition, higher voltage could destroy the sludge structure near the anode at the later stage of EDW process, leading to the decrease of SRF and SMC. These results expanded the knowledge about changes in sludge properties and water holding capacity during EDW process.