Related Experiment Video
Updated: Dec 12, 2025

Two-way Valorization of Blast Furnace Slag: Synthesis of Precipitated Calcium Carbonate and Zeolitic Heavy Metal Adsorbent
Published on: February 21, 2017
A two-step pH control method to remove divalent metals from near-neutral mining and metallurgical waste drainages by
Franco Frau1, Roberta Atzori1, Carla Ardau1
1Department of Chemical and Geological Sciences, University of Cagliari, Cagliari, Italy.
Abstract:
A neutral M2+-rich and M3+-poor (M = metal) metallurgical waste drainage was used to test a metal removal method based on the precipitation of layered double hydroxide (LDH). The LDH precipitation was induced by adding a salt of Al3+ (trivalent metal missing in the drainage) and maintaining or restoring the pH to a circum-neutral value. The precipitates were characterized by chemical analysis, XRD, ESEM, HRTEM and XAS. The main parameter controlling the removal of metals and the type of precipitate appeared to be the pH. As a function of pH variation during the experiments, analyses of precipitates and solutions showed either the formation of poor crystalline LDH combined with very high removal of Zn, Ni and Pb (92-100%), more variable removal of Mn (46-98%) and less Cd (33-40%), or the formation of more crystalline LDH combined with lower removal of Zn (62%), Mn (43%), Ni (88%), Pb (64%) and especially Cd (1%). The different metal removal efficiency in the two cases is only indirectly due to the different LDH crystallinity, and it is clearly affected by the following factors: 1) the two pH steps of the method; 2) the direction of pH variation within each step. In particular, the highest removal of metals is obtained when the first pH step goes towards acidic conditions, as a consequence of Al salt addition, and precipitation of a quasi-amorphous hydrated hydroxysulfate of Al (probably a precursor of felsӧbányaite Al4(SO4)(OH)10 · 4H2O) occurs. This first acidic pH step removes little or no metals (just 0-3%) but it is essential so that the second pH step towards slightly alkaline conditions, as a consequence of NaOH addition, can be highly efficient in removing divalent metals as the quasi-amorphous hydrated hydroxysulfate of Al gradually turns into an LDH incorporating Zn, Mg and other metals. On the contrary, when both pH steps remain in the neutral-alkaline range, only LDH precipitation occurs and a lower metal removal is observed. These results encourage further investigations on the removal of metals by inducing LDH precipitation as a simple and effective method for the treatment of circum-neutral polluted drainages.
More Related Videos
05:52Resource Recycling of Red Soil to Synthesize Fe2O3/FAU-type Zeolite Composite Material for Heavy Metal Removal
Published on: June 2, 2022
10:31Detection and Recovery of Palladium, Gold and Cobalt Metals from the Urban Mine Using Novel Sensors/Adsorbents Designated with Nanoscale Wagon-wheel-shaped Pores
Published on: December 6, 2015
Related Concept Videos
Extraction: Advanced Methods
Factors Affecting Solubility
Precipitation and Co-precipitation
Qualitative Analysis
For instance, group IV...
Coagulation
Electrodeposition
Electrodeposition can...