Efficient removal of hexavalent chromium from electroplating wastewater using polypyrrole coated on cellulose sulfate...

In this study, cellulose sulfate was synthesized through sulfonation of cotton, and polypyrrole was coated on the surface of fibers. Then, the optimum ratio of pyrrole to cellulose sulfate was evaluated, and the physical, chemical, and morphological properties of the composite were assessed by using FESEM, EDS, FTIR, BET, and TGA analysis. Furthermore, adsorption of hexavalent chromium using the composite adsorbent was studied by the results of designed experiments with the Box-Behnken technique to assess the effect of pH, contact time, adsorbent dose and the initial concentration of hexavalent chromium and optimize the adsorption process. The removal percentage was 99.9% under the optimum conditions (adsorbent dose, 4 g L-1; initial concentration of Cr(VI), 200 mg L-1; pH value, 2; contact time, 200 min). The results of adsorption isotherms illustrated that the adsorption process followed Redlich-Peterson, Freundlich, Radke-Prausnitz, and UT models, and the calculated maximum adsorption capacity by the Langmuir model was 198 mg g-1. Based on the kinetic and thermodynamic studies, the adsorption process followed the intraparticle diffusion model and showed the endothermic and spontaneous adsorption with an increase in entropy on the adsorbent surface. The presence of copper, nickel and zinc cations had no adverse effect on the removal percentage of hexavalent chromium significantly. The adsorbent was reused successfully in four sequential treatments. Consequently, the synthesized adsorbent is efficient due to the high efficiency of hexavalent chromium removal percentage from electroplating effluent (99.87%).