Effect of Reverse Shoulder Arthroplasty Lateralization Design on Scapular Notching: A Single-Surgeon Experience

Scapular notching remains a concern with both medialized and lateralized reverse shoulder arthroplasty (RSA) designs. Few studies have directly compared the rate of notching among various designs. The purpose of this study was to compare a single surgeon's rate of scapular notching in relation to RSA design. A total of 156 primary RSAs were performed for cuff tear arthropathy or osteo-arthritis with rotator cuff insufficiency by a single surgeon. Follow-up was controlled to between 3 and 5 years. Shoulders were grouped according to implant design: medialized center of rotation (CoR; n=17), lateralized CoR (n=14), and lateralized humerus (n=125). Objective clinical outcomes, patient-reported outcomes, and radiographic outcomes were compared. Scapular notching occurred more frequently with medialized CoR (82%) and lateralized CoR (57%) designs compared with a lateralized humerus design (22%; P<.001). Mean notching grade was also lower in the lateralized humerus design (0.2) compared with the medialized CoR (2.1; P<.001) and lateralized CoR (1.1; P=.01) designs. Postoperative pain, range of motion, and patient-reported outcomes were not significantly different among groups. A low rate of reoperation was seen in all groups. The lateralized humeral RSA design showed less frequent and less severe scapular notching compared with medialized CoR and lateralized CoR designs. There were no observed differences in range of motion or patient-reported outcomes between different implant designs. [Orthopedics. 2020;43(6):e585-e591.].