Surface Geometry of Four Conventional Nanohybrid Resin-Based Composites and Four Regular Viscosity Bulk Fill...

The aim of the study was to determine the quantitative and qualitative surface structure of contemporary RBCs in posterior teeth reconstructions: regular viscosity bulk fill and conventional composites, obtained after two-stage polishing procedure.

Four conventional nanohybrid composites (Tetric EvoCeram, GrandioSO, Filtek Z550, and Ceram·X Mono) and four regular viscosity bulk fill composites (Tetric EvoCeram Bulk Fill, X-tra fil, Filtek Bulk Fill Posterior, and QuixFil) were tested. Samples of each RBC were prepared using PMMA cylindrical mold. After two-step polishing procedure, a surface geometry was evaluated under profilometry (Turbowave v. 7.36, Hommel-Etamic) and SEM (VEGA 3, Tescan Analytics). To evaluate differences between values, the following nonparametric tests were used: Friedman's ANOVA, Wilcoxon's matched-pair test, ANOVA Kruskal-Wallis, and Mann-Whitney U.

All conventional RBCs showed Ra values in the range of 0.20-0.26 μm. Bulk fill showed higher values in range of 0.49-1.36 μm except for Filtek Bulk Fill Posterior, which achieved 0.23 μm Ra value. SEM images of conventional RBCs were described as smooth surfaces with slight damage except for TEC, which presented smooth surface with no damage. Bulk fill composites showed rough surface, except for TBF, which presented smooth surface with slight damage.

Regular viscosity bulk fill composites do not constitute a homogeneous group regarding surface roughness after polishing. They obtain, for the most part, poorer smoothness values after polishing than conventional RBCs.