Related Experiment Video
Updated: Dec 10, 2025

X-ray Beam Induced Current Measurements for Multi-Modal X-ray Microscopy of Solar Cells
Published on: August 20, 2019
Choice of low-pass filter influences practical interpretation of ball kicking motions: the effect of a time-frequency
Simon Augustus1, Arif Mithat Amca2, Penny E Hudson1
1Chichester Institute of Sport, University of Chichester, Chichester, UK.
Abstract:
When studying ball kicking, conventional low-pass filters may distort kick leg kinematics near the time of foot-to-ball contact, leading to flawed practical interpretation of the skill. Time-frequency filters are a viable alternative but are not widely used. This study compared a fractional Fourier filter (FrFF) with conventional filters (CF) methods for estimating common parameters used to define kicking performance. Instep kicks from 23 experienced soccer players were captured by 3D motion analysis (1000 Hz), and kick leg foot velocities, knee angular velocities and ankle dorsi-plantarflexion angles compared between the FrFF and variations of a Butterworth CF. The FrFF and CFs using a higher cut-off frequency (>70 Hz) successfully detected lower leg motion prior to, during and following impact, whereas CFs with low cut-off frequencies (<20 Hz) attenuated motion near impact. Truncating data at impact provided valid pre-impact kinematics, but ignored information thereafter. Rather than decelerating the lower leg to conserve accuracy, 'kicking through the ball' should be considered a valid coaching cue. Further, controlling ankle plantar flexion to ensure efficient impact mechanics may be important for skilled kicking. Practitioners should consider how choice of filter will affect their data, and use of time-frequency methods can help inform empirically grounded coaching practices.
Related Concept Videos
Passive Filters
Low-Pass Filters
Low-pass filters are designed to transmit signals with frequencies lower than the cutoff frequency, ωc, and attenuate those above it. The cutoff...
Active Filters
Bandpass Sampling
A bandpass signal has a spectrum with a lower frequency limit, denoted as ω1, and an upper frequency limit, denoted as ω2....
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any...
Frequency Response of a Circuit
The transfer function is pivotal in characterizing how these circuits react to various frequencies, facilitating a profound understanding of their behavior. An essential parameter is the time constant, signifying the...
Aliasing
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original...

