Ab Initio-Based Global Potential Energy Surface and Reaction Dynamics for H2S + C

Marziyeh Sadat Masoumpour1, Marzieh Daryanavard1

  • 1Department of chemistry, Estahban Higher Education Center, Estahban 74519-44655, Iran.

Related Concept Videos

Calculating Standard Free Energy Changes02:49

Calculating Standard Free Energy Changes

The free energy change for a reaction that occurs under the standard conditions of 1 bar pressure and at 298 K is called the standard free energy change. Since free energy is a state function, its value depends only on the conditions of the initial and final states of the system. A convenient and common approach to the calculation of free energy changes for physical and chemical reactions is by use of widely available compilations of standard state thermodynamic data. One method involves the...
24.3K
Hess's Law03:40

Hess's Law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.
53.5K
Energy Diagrams, Transition States, and Intermediates02:13

Energy Diagrams, Transition States, and Intermediates

Free-energy diagrams, or reaction coordinate diagrams, are graphs showing the energy changes that occur during a chemical reaction. The reaction coordinate represented on the horizontal axis shows how far the reaction has progressed structurally. Positions along the x-axis close to the reactants have structures resembling the reactants, while positions close to the products resemble the products.  Peaks on the energy diagram represent stable structures with measurable lifetimes, while...
19.3K
Acid-Catalyzed Hydration of Alkenes02:45

Acid-Catalyzed Hydration of Alkenes

Alkenes react with water in the presence of an acid to form an alcohol. In the absence of acid, hydration of alkenes does not occur at a significant rate, and the acid is not consumed in the reaction. Therefore, alkene hydration is an acid-catalyzed reaction.
16.7K
Valence Bond Theory and Hybridized Orbitals02:38

Valence Bond Theory and Hybridized Orbitals

According to valence bond theory, a covalent bond results when: (1) an orbital on one atom overlaps an orbital on a second atom, and (2) the single electrons in each orbital combine to form an electron pair. The strength of a covalent bond depends on the extent of overlap of the orbitals involved. Maximum overlap is possible when the orbitals overlap on a direct line between the two nuclei.
A σ bond (single bond in a Lewis structure) is a covalent bond in which the electron density is...
26.6K
Electrophilic Addition of HX to 1,3-Butadiene: Thermodynamic vs Kinetic Control01:23

Electrophilic Addition of HX to 1,3-Butadiene: Thermodynamic vs Kinetic Control

The addition of a hydrogen halide to 1,3-butadiene gives a mixture of 1,2- and 1,4-adducts. Since more substituted alkenes are more stable, the 1,4-adduct is expected to be the major product. However, the product distribution is strongly influenced by temperature; low temperature favors the 1,2-adduct, whereas the 1,4-adduct is predominant at high temperature.
3.3K