Related Experiment Video
Updated: Dec 9, 2025

Emission Spectroscopic Boundary Layer Investigation during Ablative Material Testing in Plasmatron
Published on: June 9, 2016
Always Lost but Never Forgotten: Gas-Phase Wall Losses Are Important in All Teflon Environmental Chambers
Jordan E Krechmer1, Douglas A Day2, Jose L Jimenez2
1Aerodyne Research, Inc., Billerica, Massachusetts 01821, United States.
Abstract:
Yields of secondary organic aerosol (SOA) formation from oxidation of volatile organic compounds are measured in laboratory chambers and then applied in regional and global models. Gas-phase losses to large Teflon-walled environmental chambers have been recently shown to reduce SOA yields. Historically, most chambers have operated in batch mode. Increasingly, however, continuous flow (CF) mode is being used, in which reactants and products are continuously introduced and exhausted from the chamber. Recent literature reports indicate a belief that SOA yields measured in CF chambers are not affected by gas-phase wall losses (GWL). Here, we use an experimentally-constrained box model to show that gas-phase wall losses impact both types of chambers when run under similar conditions. We find CF experiments do mitigate some effects of gas-phase wall losses after long (>2 days) experiment run times, but they have significant losses for typical literature experiment times of 1 day. However, this mitigation phenomenon is an experiment- and mechanism-dependent, and GWL still affects the absolute SOA yield. Finally, we show that at condensation sink values higher than the wall loss rate a lack of change in yield vs seed surface area does not necessarily indicate whether GWL affects the experiment and does not suggest the magnitude.
Related Concept Videos
Conduction, Convection and Radiation: Problem Solving
In order to solve a problem related to heat transfer, first of all, the situation needs to be examined to determine the type of heat transfer involved. This could...
Thermal Insulation in Masonry Walls
External insulation can be applied using an Exterior Insulation and Finish System (EIFS), which involves affixing panels of plastic foam to the wall and covering them with a polymeric stucco reinforced with glass fiber mesh....

