Related Experiment Video
Updated: Dec 8, 2025

Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
Strength Characteristics of Sand-Silt Mixtures Subjected to Cyclic Freezing-Thawing-Repetitive Loading
Jong-Sub Lee1, Jung-Doung Yu1, Kyungsoo Han2
1School of Civil, Environmental and Architectural Engineering, Korea University, 145, Anam-ro, Seongbuk-gu, Seoul 02841, Korea.
Abstract:
Daily freezing-thawing-repetitive loading is a critical factor affecting soil stability. This study assesses the strength of sand-silt mixtures with various silt fractions (SFs) subjected to cyclic freezing-thawing-repetitive loading. Specimens with SF of 0-100% were prepared with a fixed relative density of 60%. The number of repetitive loadings (N) was 1, 100, and 1000 for each specimen with different SFs. After three cycles of freezing-thawing-repetitive loading, the specimens were frozen at -5 °C for the uniaxial compression test. Test results show that the change in relative density (∆Dr) increases with the increase in SF up to 30% and decreases as SF increases beyond 30% owing to the change in the void ratio. The volumetric unfrozen water content (θu) increases with the increase in both SF and N owing to the effect of the physicochemical characteristics of soils on small voids. Unconfined compressive strength of sand-dominant mixtures (SF ≤ 30%) is reinforced by ∆Dr. By contrast, for silt-dominant mixtures (SF > 30%), the unconfined compressive strength decreases with the increase in θu and N due to lubricant role and sands dispersion. Thus, the effects of SF and N should be considered for sand-silt mixtures that have a probability to undergo cyclic freezing-thawing-repetitive loading.
More Related Videos
06:27Sandy Soil Improvement through Microbially Induced Calcite Precipitation MICP by Immersion
Published on: September 12, 2019
09:00Visualization of Failure and the Associated Grain-Scale Mechanical Behavior of Granular Soils under Shear using Synchrotron X-Ray Micro-Tomography
Published on: September 29, 2019
Related Concept Videos
Frost Resistant Concrete
Introducing microscopic air bubbles into the concrete mix through air entrainment creates small voids that accommodate ice expansion, thereby reducing internal pressures and preventing cracking. The optimal amount of...
Unsoundness of Aggregate due to Volume Change
Frost Action on Concrete
This freeze-thaw cycle primarily causes surface scaling, where...
Effects of Air-entrainment in Concrete
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Fatigue Strength of Concrete