Related Experiment Video
Updated: Dec 8, 2025

An Analog Macroscopic Technique for Studying Molecular Hydrodynamic Processes in Dense Gases and Liquids
Published on: December 4, 2017
Motion behaviour of ellipsoidal granular system under vertical vibration and airflow
Mengxiang Jiang1, Ping Wu2, Haowei Liu2
1School of Energy and Environmental Engineering, University of Science and Technology Beijing, Beijing 100083, China.
Abstract:
We studied the motion behaviour of ellipsoid particles under vertical vibration and airflow. Three typical convection patterns were observed when submitted to vertical vibration with frequency (f) from 20 Hz to 80 Hz and dimensionless vibration acceleration (Γ) from one to six. We studied the effects of f and Γ on the change of convection patterns. We quantitatively studied the effects of f, Γ, airflow direction, airflow velocity, and particle shape on the convection area and intensity using the area fraction λ and average velocity vz characterizing the convection area and intensity, respectively. Results showed that the convection first occured occurred in the upper part of the granular system. Increasing f and A can both increase the convection area and strengthen the convection intensity. A had a greater influence than f at the same Γ. The wheat particles were more likely to enter the global convection state under the action of the airflow in the opposite direction of gravity. The maximum convection intensity of wheat particles under the airflow in the opposite direction of gravity was approximately 30-35% of the value measured under the airflow along the direction of gravity. The convection area and maximum convection intensity of the spherical particles were approximately 85% and 93% of the measured values for the ellipsoidal particles, respectively. We also analysed the effects of f, Γ, airflow direction, airflow velocity, and particle shape on the convection area on the basis of energy dissipation.
More Related Videos
Related Concept Videos
Equation of Motion: General Plane motion - Problem Solving
The friction between the roller and the ground is characterized by two coefficients. The static friction coefficient is 0.15, while the kinetic friction coefficient is 0.1. These values are crucial in understanding the interaction between...
Dynamics of Circular Motion
Any acceleration must be produced by some force. Therefore, any force or combination of forces can cause centripetal acceleration. A few examples include the tension in the rope on a...
Stability of Equilibrium Configuration: Problem Solving
Problem-solving in the context of the stability of equilibrium configuration...
Steady, Laminar Flow Between Parallel Plates
Dynamics Of Circular Motion: Applications
Equation of Motion: General Plane motion
Moreover, the body's center of mass experiences a rotational effect as a result of these couple moments. This rotation can be articulated as the...

