Hydrophilic modification of polycarbonate surface with surface alkoxylation pretreatment for efficient separation of...

Waste polystyrene (PS) and polycarbonate (PC) are crucial components arising from mixtures of plastic products, whose recycling is significantly limited by separation efficiency. In this work, to assist the flotation separation of PC and PS, we proposed a novel modification technology of surface alkoxylation pretreatment (SAP) where PC surface reacted with glycerol and urea. The SAP could selectively transform the hydrophobic PC into hydrophilic plastic, while the PS remained its hydrophobic surface owing to the exclusion from SAP process. Benefiting from the hydrophilic PC, the separation efficiency of PS and PC could reach the maximum of 99.34% under optimum conditions (urea dosage of 5 g, pretreatment temperature of 130 °C, pretreatment time of 10 min, flotation time of 2.5 min, frother concentration of 16.5 mg/L, and airflow rate of 7.2 mL/min). The mechanism of SAP was systematically analyzed by wettability, surface morphology, molecular weight, and chemical reactions. Compared with PS plastic, the pretreated PC presented better wettability, rougher surface, and significantly reducing molecular weight. The improvement of PC hydrophilicity can be attributed to the cleavage of ester bonds on backbone chains and the introduction of hydrophilic hydroxyl groups. The effective SAP process proves that chemical recycling of waste plastic can provide a novel strategy for surface modification and flotation separation of PS and PC.