Rising obstacle in a one-layer granular bed induced by continuous vibrations: two dynamical regimes governed by

Hui Zee Then1, Teruyo Sekiguchi1, Ko Okumura1

  • 1Physics Department and Soft Matter Center, Ochanomizu University, Tokoyo 112-8610, Japan. okumura@phys.ocha.ac.jp.

Soft Matter
|September 30, 2020
PubMed

Related Concept Videos

Vibrating Concrete01:19

Vibrating Concrete

Mechanical vibrators are instrumental in compacting newly poured concrete within formwork and around reinforcements. This process is essential to eliminate trapped air pockets and establish a dense concrete mass. One widely used method is vibrating by internal vibrators, often referred to as a poker vibrator or immersion vibrator. It is rapidly inserted through the full depth of the freshly laid concrete and slightly extends into the layer below it (which remains in a plastic state). Consistent...
283
Forced Oscillations01:06

Forced Oscillations

When an oscillator is forced with a periodic driving force, the motion may seem chaotic. The motions of such oscillators are known as transients. After the transients die out, the oscillator reaches a steady state, where the motion is periodic, and the displacement is determined.
7.4K
Variation in Acceleration due to Gravity near the Earth's Surface01:20

Variation in Acceleration due to Gravity near the Earth's Surface

An object's apparent weight is its weight measured by a spring balance at its location. It is different from its true weight, the force with which the Earth pulls it, because of the Earth's rotation. Mathematically, an object's apparent weight equals its true weight minus the centripetal force that keeps it in a circular motion along with the Earth's surface every 24 hours.
The difference between the true and apparent weights is proportional to the square of the Earth's...
2.6K
Damped Oscillations01:07

Damped Oscillations

In the real world, oscillations seldom follow true simple harmonic motion. A system that continues its motion indefinitely without losing its amplitude is termed undamped. However, friction of some sort usually dampens the motion, so it fades away or needs more force to continue. For example, a guitar string stops oscillating a few seconds after being plucked. Similarly, one must continually push a swing to keep a child swinging on a playground.
Although friction and other non-conservative...
6.6K
Limits with Oscillating Discontinuities01:19

Limits with Oscillating Discontinuities

An oscillating discontinuity is a type of discontinuity in which a function’s values fluctuate infinitely often as the input approaches a particular point. Unlike jump discontinuities, where the function suddenly shifts between two values, or infinite discontinuities, where the function diverges without bound, an oscillating discontinuity arises from rapid back-and-forth variation. Because the function never stabilizes toward a single value, no finite limit exists at that point.One of the...
137
Gradually Varying Flow01:29

Gradually Varying Flow

Gradually varying flow (GVF) in open channels describes situations where water depth changes slowly along the channel due to factors like non-uniform bed slope, channel shape variations, or obstructions. This flow type occurs when the depth adjusts gradually to balance gravitational forces, shear forces, and energy requirements, resulting in a low rate of depth change.Characteristics of Gradually Varying FlowGVF is commonly observed in natural streams, rivers, and canals, where flow depth...
293