Comparison of the different voxel sizes in the estimation of peri-implant fenestration defects using cone beam...

To examine the influence of voxel sizes to detect of peri-implant fenestration defects on cone beam computed tomography (CBCT) images.

This study performed with three sheep heads both maxilla and mandible and two types of dental implant type 1 zirconium implant (Zr⁴⁰) (n = 6) and type 2 titanium implant (Ti²²) (n = 10). A total of 14 peri-implant fenestrations (8 buccal surfaces, 6 palatal/lingual surface) were created while 18 surfaces (8 buccal, 10 palatal/lingual) were free of fenestrations. Three observers have evaluated the images of fenestration at each site. Images obtained with 0.75 mm³, 0.100 mm³, 0.150 mm³, 0.200 mm³, and 0.400 mm³ voxel sizes. For intra- and inter-observer agreements for each voxel size, Kappa coefficients were calculated.

Intra- and inter-observer kappa values were the highest for 0.150 mm³, and the lowest in 0.75 mm³ and 0.400 mm³ voxel sizes for all types of implants. The highest area under the curve (AUC) values were found higher for the scan mode of 0.150 mm³, whereas lower AUC values were found for the voxel size for 0.400 mm³. Titanium implants had higher AUC values than zirconium with the statistical significance for all voxel sizes (p ≤ 0.05).

A voxel size of 0.150 mm³ can be used to detect peri-implant fenestration bone defects. CBCT is the most reliable diagnostic tool for peri-implant fenestration bone defects.