Related Experiment Video
Updated: Dec 7, 2025
Original Experimental Approach for Assessing Transport Fuel Stability
Published on: October 21, 2016
Effect of additives on the stability of ethanol-diesel blends for IC engine application
Ramkumar Shanmugam1, Parthasarathy Murugesan2, Gedisa Gudeta Guye3
1Department of Automobile Engineering, Vel Tech Rangarajan Dr. Sagunthala R&D Institute of Science and Technology, Chennai, India. yesram98@gmail.com.
Abstract:
The present research work was conducted on a compression ignition engine to assess the engine characteristics fueled with the blend of diesel and high-oxygenated additives such as ethanol. Ethanol does not easily blend with diesel. In order to attain a homogeneous mixture, a small amount of additive is added to the blend. Different additives were added to the blend to form a homogeneous mixture. Stability test was conducted on the blend to ensure prolonged homogeneity. The additives used for the test purpose were isopropanol, oleic acid, and ethylene acetate. From the stability results, it was found that oleic acid was the best additive which produces a better homogenous mixture for the blend of ethanol and diesel. One percentage of oleic acid is used as an additive to blend ethanol and diesel. The different combinations of blend ratios used for the test purpose were D90E10, D80E20, and D70E30. All the aforementioned blends have low cetane number because of ethanol, which was compensated by adding 1% DEE (diethyl ether) to all the blends. Experimental results exhibit that there is an improvement in the performance characteristics, such as brake thermal efficiency (BTE) and specific energy consumption (SEC), with the enrichment of DEE in ethanol-diesel blend. It is also noticed that the blend without DEE exhibited lower magnitude. This is mainly due to higher energy content and cetane number of DEE. Emission characteristics, like hydrocarbon (HC) and carbon monoxide (CO), were found to drastically increase with the increase in the ethanol concentration in the diesel blend. This is attributed to higher latent heat of vaporization (LHV) of ethanol present in the blend. Combustion pressure and heat release rate of the DEE-enriched ethanol blends were higher by 2.2 % and 2.4 %, respectively, when compared with their corresponding blends without DEE. This is a result of higher volatility of DEE which leads to better combustion. Graphical abstract.
Related Concept Videos
01:59Relative Stabilities of Alkenes
02:14Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified...
01:28Stability of Conjugated Dienes
A comparison of the enthalpies of hydrogenation of dienes reveals that conjugated dienes release less heat on hydrogenation, rendering them more stable than their nonconjugated analogs.
01:05Bioavailability Enhancement: Drug Stability Enhancement and GI Retention
02:17Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
01:23Electrophilic Addition of HX to 1,3-Butadiene: Thermodynamic vs Kinetic Control