Investigation of a biosystem based on Arthrospira platensis for air revitalisation in spacecrafts: Performance...

Arthrospira platensis is featured as a promising microalgae candidate for the development of the biosystems for air revitalisation in spacecrafts and life support in space. An enhanced configuration of a sparged type photobioreactor (PBR), containing 5 L of A. platensis culture, which was equipped with an external LED lighting tube around the reactor, was used in this study. The PBR was operated under dynamic conditions (0.5 L/min) with synthetic air containing CO₂ (400, 900, 1400 ppm) and other gas traces (NO₂ 1 ppm, SO₂ 2.5 ppm, acetic acid vapours 1 ppm), at various light intensities (1.5, 2.5, 3.5 klux), according to an experimental design. The removal of gas traces (NO₂, SO₂ and acetic acid vapours) was below the detection limit (e.g. above 90% removal efficiency), while the removal of CO₂ ranged between 69% and 85%, depending on the initial CO₂ concentration and the light intensity. Thus, the system is able to roughly decrease the contaminant concentration from 1 ppm to below 0.1 ppm for NO₂, 2.5 ppm to below 0.1 ppm for SO₂, 1 ppm to below 1 ppb for acetic acid vapours and from 1400 ppm to 370 or from 400 ppm to 60 ppm for CO₂. The system performance was thus subject to mathematical modelling and optimization in terms of CO₂ removal efficiency and CO₂ elimination capacity, which were also corroborated with the power consumption for illumination.