[Effect of Porous Fillers Properties on Biofilm Growth]

As an important part of biological aerated filters (BAFs), porous fillers are key to the effectiveness of BAF wastewater treatment. At present, there are many types of fillers, but the influence of the surface physical and chemical properties on biofilm formation is unclear, and how to compare and select the best biological filler remains a difficult problem in BAF engineering applications. In this study, the physical and chemical characteristics of several porous biological fillers that are commonly used in BAFs were studied, and the correlation between their physical/chemical properties and the biofilm attachment and enzyme activity of the biofilm on the filler was investigated. The results showed that the sponge filler could easily absorb sludge, but also clogged easily and the overall biofilm activity was not high. The three-dimensional hollow filler had a low surface-adsorbed biomass, but the specific surface area was large and the surface attachment growth biofilm activity was relatively strong. Ceramsite had a good hydrophilicity and high surface roughness, and the zeta potential was the most positive. Moreover, microorganisms easily attached and grew, it had the strongest sludge adhesion performance, and the best biofilm activity. According to a redundancy analysis (RDA), the main factor affecting the biomass on the surface of the fillers was the zeta potential, whereas the main factors affecting the surface sludge activity of the fillers was the clearance rate. According to the removal load of NH₄⁺-N by six groups of reactors, the removal load of NH₄⁺-N by ceramsite was the largest [68 g·(m³·d)^-1], and was followed by volcanic rocks [67 g·(m³·d)^-1]. Combined with the above factors, ceramsite was determined to be the most suitable filler for BAF.