[Influence of Typical Desulfurization Process on Flue Gas Particulate Matter of Coal-fired Boilers]

As flue gas desulfurization (FGD) was one of the most important purification processes of coal-fired boilers, we selected four boilers, which were equipped with wet limestone, furnace calcium injection, ammonia-based, and double-alkali FGDs, to research the influence of FGDs on the flue particulate matter (PM). The flue PM before and after the FGD were sampled using laboratory resuspension and dilution tunnel sampling methods, respectively, and the PM was analyzed for its chemical composition (i.e., ions, elements, and carbon). The results showed that the types of desulfurizers could influence the composition of the flue PM. After passing through the wet limestone, ammonia-based, and double-alkali FGDs, the proportion of Ca, NH₄⁺, and Na in PM_2.5 increased from 5.1% to 24.8%, from 0.8% to 7.3%, and from 0.9% to 1.7%, respectively. The influence of wet and dry FGDs on the flue PM were different. The fraction of ions in the PM emitted from the wet FGD were higher than those from the dry FGD. The proportion of SO₄^2- in the flue PM_2.5 increased from 2.0% and 6.7% to 9.6% and 11.9% using the wet limestone and ammonia-based FGDs, respectively, and Cl^- increased from 0.4% and 1.2% to 3.8% and 5.2%. In addition, the amount of heavy metals (e.g., Cr, Pb, Cu, Ti, and Mn) in PM_2.5 declined after the wet FGDs. The PM_2.5 emitted from the dry FGD boiler was richer in crustal elements, such as Al, Si, and Fe, than that from the wet FGDs. The wet FGDs also effected the carbonaceous components of the flue PM. After passing through the wet limestone and ammonia-based FGDs, the proportion of elemental carbon in the flue PM_2.5 decreased from 6.1% to 0.9% and from 3.6% to 0.7% respectively, but the organic carbon content did not decrease.